Pro-Ject Audio Systems Box-Design MaiA S3 Instructions For Use Manual Download Page 6

© Pro-Ject Audio Systems · MaiA S3 · Revision 2022.01.03 

 

 

6

 

 
Waste from Electrical and Electronic Equipment (WEEE): This directive mandates the collection and recycling 
of electronics and component materials in order to reduce the amount going to landfills. Outside North 
America, when the user decides to discard this product, it must be sent to a separate collection facility for 

recycling. Please contact your point of purchase for more details.

 

 

 

Federal Communication Commission (FCC) Interference Statement FCC Part 15: This equipment has been 
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the following measures: 
- Reorient or relocate the receiving antenna 
- Increase the separation between the equipment and receiver 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected 
- Consult the dealer or an experienced radio/TV technician for help. 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment 
complies with FCC radiation exposure limits set forth for an uncontrolled environment.  
To maintain compliance with FCC´s RF exposure guidelines, this equipment should be installed and operated 

with minimum distance 20cm between the radiator and your body. Use on the supplied antenna. 
Contains FCC ID: 2AMWO-FSCBT1026 

 

Declaration of Conformity 

 

We, Canor spol. s r.o.  
Družstevná 13925/39 
08006 Prešov 
Slovakia   
(manufacturer) 

 

and 
Pro-Ject Audio Systems a division of Audio Tuning GmbH 
Margaretenstrasse 98 
1050 Vienna,  
Austria 
(distributor) 

 

declare under our responsibility that the product is in conformity with the provisions of Directives: 
2014/35/EU including amendments 

2014/30/EU including amendments 
2014/53/EU including amendments 

 

The following harmonised standards were applied: 
Health: EN62479:2010 
Safety: EN60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013, EN62368-1:2014/A11:2017, 
EN61558-1:2005/A1:2009, EN61558-2-16:2009/A1:2013 
EMC: EN301489-1 V2.2.0: 2017-03, EN301489-17 V3.2.0:2017-03, EN55032:2015, EN55035:2017, 
EN61000-3-2:2014, EN61000-3-3:2013 
Radio Spectrum: EN300328 V2.1.1 (2016-11) 

 

Pro-Ject Audio Systems a division of Audio Tuning GmbH 

1050 Vienna, Austria, Margaretenstrasse 98 
[email protected] 

Summary of Contents for Box-Design MaiA S3







Reviews: