12
14. Lift the latch on the underside of the Left Pedal
Arm (14), and set the Left Pedal Arm on the left
Crank Bushing Sleeve (43).
Release the latch, and make sure that the Left
Pedal Arm (14) is securely connected to the
Crank Bushing Sleeve (43).
Connect the Right Pedal Arm (not shown) in
the same way.
See step 5
. Tighten the M8 x 69mm Button Bolt
(80) and the two M8 x 23mm Button Screws
(84).
15.
Make sure that all parts of the elliptical exerciser are properly tightened.
Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Latch
43
14
13. Apply grease to a Pedal Arm Axle (32) and to
the two Pedal Arm Bearings (33) in the Left
Pedal Arm (14).
Next, tighten an M8 x 23mm Shoulder Screw
(115), an M8 Washer (88), and a Pedal Arm
Cover (31) into one end of the Pedal Arm Axle
(32).
Do not fully tighten the Shoulder Screw
yet.
While another person holds the Left Pedal Arm
(14) inside the bracket on the Left Upper Body
Leg (11), insert a Bearing Spacer (118) into
each side of the bracket.
Insert the Pedal Arm Axle (32) into the Left
Upper Body Leg (11) and the Left Pedal Arm
(14).
Tighten another M8 x 23mm Shoulder Screw
(115), M8 Washer (88), and Pedal Arm Cover
(31) into the other end of the Pedal Arm Axle
(32).
Fully tighten both M8 x 23mm Shoulder
Screws (115).
Repeat this step to attach the Right Pedal
Arm (not shown) to the Right Upper Body
Leg (12).
Grease
13
115
32
88
31 118
118
12
11
14
115
88
33—Grease
Bracket
31
14
