5
1.
Refer to the drawing on page 4 and identify the left
side of the treadmill.
With the help of a second person,
carefully lay the treadmill on its left side.
Firmly slide an Extension Leg (99) into the Base (70) as
shown. Make sure that the Extension Leg is turned so
the Base Pad (89) is on the indicated side. Using the in-
cluded Allen Wrench (92), attach the Extension Leg with
an Extension Screw (93). While the treadmill is on its
side, attach the other Extension Leg (not shown) in the
same manner.
With the help of a second person, carefully raise the
treadmill to the vertical position so both Extension Legs
(99) are resting flat on the floor.
93
92
70
99
89
1
2. Remove the four Latch Screws (108) from the left
Upright (70).
Without removing the tape from the Latch Bracket (60)
and Latch Spacer (66), hold both parts against the left
Upright (70) as shown. Attach the Latch Bracket and
Latch Spacer with the four Latch Screws (108).
Make
sure that the Screws are tight, but do not over-
tighten them; if the Screws are overtightened, the
Storage Latch (69) will not slide smoothly.
After the
parts are attached, remove any visible tape.
Note: The inset drawing shows how the Latch Bracket
(60), Latch Springs (68), Storage Latch (69), and Latch
Spacer (66) fit together.
3. Remove the indicated Screw (4) from the treadmill
Frame (1). Attach the plastic Catch (5) to the Frame with
the Screw. Note: It may be necessary to slide the
Storage Latch (69) to the left while attaching the Catch.
4
5
1
69
3
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not
dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench , and your own adjustable wrench , and a
phillips screwdriver .
66
108
70
69
60, 66
60
69
68
2
