8
7.
Make sure that all parts are properly tightened before you use the treadmill.
Note: Extra hardware may
be included. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking
belt (see page 27). To protect the floor or carpet, place a mat under the treadmill. If there are thin sheets of
clear plastic on the decals, remove them.
6. Fold the treadmill to the storage position (see page 24).
If the Wheels (94) are resting on the floor, or if the tread-
mill rocks slightly, turn one or both of the Leveling Feet
(95) under the Uprights (97) until the Wheels are off the
floor and the rocking motion is eliminated. Note: If neces-
sary, tip the treadmill and use a phillips screwdriver to
turn the Leveling Feet.
6
95
94
94
97
5. Set the Console Base (101) on the Uprights (97). Thread
the four Upright Bolts (76) with four Internal Star
Washers (77) into the Uprights and the Console Base.
Be careful not to pinch the Wires (not shown) in the
Uprights.
Tighten the two Upright Bolts indicated by the
arrows first; then, tighten the remaining two Upright Bolts.
Make sure that the Left and Right Trays (109, 111) are
pressed into the Console Base (101).
76
77
101
76
77
111
109
97
97
5
77
25
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand as
shown. Using your left hand, pull the latch knob to the left
and hold it. Pivot the treadmill down until the frame is past
the latch pin. Slowly release the latch knob.
2. Hold the treadmill firmly with both hands, and lower the tread-
mill to the floor.
Do not drop the treadmill frame to the
floor. To decrease the possibility of injury, bend your legs
and keep your back straight.
Frame
Latch Knob
Latch Pin
