10
7. Set the console assembly face down on a soft
surface to avoid scratching the console assem-
bly. Hold the Right Handrail (104) near the con-
sole assembly. Next, insert the console wire into
the large hole in the Right Handrail and pull it
out of the top as shown. If necessary, use
needlenose pliers to pull the console wire out.
Attach the Right Handrail (104) and the Left
Handrail (not shown) with four #8 x 3/4" Screws
(1) (only two are shown).
Make sure that no
wires are pinched. Start all four Screws, and
then tighten each of them; do not over-
tighten the Screws.
8. Start a 1/4" x 1 1/4" Bolt (10) with a 1/4" Star
Washer (14) into the bracket and the Crossbar
(102) on each side of the console assembly (only
one side is shown).
Do not fully tighten the
Bolts yet.
Remove the wire tie from the console wire and
the plastic ties (only one side is shown). If neces-
sary, press the Cage Nuts (74) back into place
(only one is shown).
1
104
Console
Wire
Console
Assembly
7
10
14
102
Console
Assembly
Wire
Tie
Console
Wire
Plastic Tie
Bracket
8
74
All manuals and user guides at all-guides.com
