8
5. Hold a Bolt Spacer (79) inside the lower end of
the Right Upright (78). Insert an M10 x 96mm
Bolt (5) with an M10 Star Washer (8) into the
Right Upright and the Bolt Spacer. Repeat this
step with a second Bolt Spacer (79), M10 x
96mm Bolt (5), and M10 Star Washer (8).
Orient the Right Upright (78) and the Right
Upright Spacer (80) as shown. Hold the Right
Upright Spacer and the Right Upright against the
Base (85).
Be careful not to pinch the Upright
Wire (77).
Finger tighten the two M10 x 96mm
Bolts (5);
do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
77 80
78
79
82
8
6. Hold a Bolt Spacer (79) inside the lower end of
the Left Upright (73). Insert an M10 x 96mm Bolt
(5) with an M10 Star Washer (8) into the Left
Upright and the Bolt Spacer. Repeat this step
with a second Bolt Spacer (79), M10 x 96mm
Bolt (5), and M10 Star Washer (8).
Orient the Left Upright (73) and the Left Upright
Spacer (83) as shown. Hold the Left Upright
Spacer and the Left Upright against the Base
(85). Finger tighten the two M10 x 96mm Bolt
(5);
do not fully tighten the Bolts yet.
Press a Base Endcap (82) into the Base (85).
85
73
5
83
8
82
79
5
6
5
Rounded
Corner
85
7. Set the Console (87) face down on a soft sur-
face to avoid scratching the Console. Identify the
Right Handrail (90), which has a large hole in the
location shown. Hold the Right Handrail near the
Console. Attach the console ground wire to the
Right Handrail with an M4 x 13mm Screw (3).
Next, insert the console wire into the large hole
in the Right Handrail (90) and out of the top as
shown. Attach the Right Handrail with three M4 x
19mm Screws (1).
Make sure that no wires are
pinched. Start all three Screws before tight-
ening any of them; do not overtighten the
Screws.
Remove the ties from the Cage Nuts (38).
Attach the Left Handrail (not shown) to the
Console (87) in the same way. Note: There are
no wires on the left side of the Console.
90
38
7
87
1
1
1
Large Hole
Console
Wire
3
Console
Ground Wire
