7
4. While a second person holds the Console (4)
near the Upright (3), connect the console wire to
the Wire Harness (46). Then, connect the pulse
wire to the Handgrip Pulse Wire (85). Insert the
excess wire downward into the Upright.
Tip: Avoid pinching the wires during this
step.
Attach the Console (4) to the Upright (3)
with four M4 x 16mm Screws (80).
4
80
3. Identify the Upright (3) and orient it as shown.
Have a second person hold the Upright near the
top of the Frame (1). Locate the wire tie (see
the inset drawing) in the Upright. Tie the lower
end of the wire tie to the Wire Harness (46).
Next, pull the upper end of the wire tie upward
out of the top of the Upright. Then, untie and
discard the wire tie.
Tip: Do not allow the Wire
Harness to fall into the Upright. Use a piece
of tape or an elastic band to hold the Wire
Harness and the Handgrip Pulse Wire (85) in
place until step 4.
Tip: Avoid pinching the Wire Harness (46)
during this step.
Slide the Upright (3) onto the
Frame (1). Attach the Upright with four M8 x
19mm Patch Screws (65).
3
4
46
85
Pulse Wire
3
1
65
65
Avoid pinching the
Wire Harness (46)
during this step
Avoid pinching the
wires during this step
Wire Tie
46
Console
Wire
46
85
3
