11
• Tightening the screws with too much
force can damage the PS-A unit.
• The necessary torque is 0.5N
•
m.
• Be sure to insert installation fasteners
in the recessed portion of an installa-
tion fasteners hole. If the fasteners are
not correctly attached, the PS-A unit
may shift or fall out of the panel.
3.
Attach the PS-A unit to an Arm
To attach the PS-A unit to an Arm or to the
wall, insert the attachment screws for a
commercial-type arm or wall mount adaptor
into the holes in the PS-A’s rear face.
(Holes specifications: VESA 75mm)
For detailed attachment instructions, please
refer to that product's installation guide. The
VESA Arm Attachment Hole dimensions are
signifies as follows;
Arm Attachment Screw Holes (VESA
75mm).
Attach the four (4) M4 attachment screws.
(Screw length: 6mm (0.24 in.) or less.) The
torque required for these screws is 0.7 to 0.8
N
•
m.
4.
Removal/Attachment the Rear
Cover
• Use a screwdriver to loosen or tighten
the screws. Be sure not to tighten
screws too tightly, since it may damage
the unit.
• Be careful when removing or inserting
any screws that they do not fall inside
the PS-A.
Unscrew the five (5) attachment screws used
to hold the Rear Cover in place, and remove
the Rear Cover. The torque of the rear cover
required for these screws is 0.5 to 0.6 N
•
m.
Wiring
• To avoid an electric shock, prior to con-
necting the PS-A unit’s power cord ter-
minals to the power terminal block,
confirm that the PS-A unit’s power sup-
Insertion Slot Recess
Hook the fastener
on the Recess,
Panel
Installation Fastener
PS-A
Hook
and secure the fastener
on the panel with a screw.
75[2.95]
75
[2.
95]
Rear Face
(unit:mm[in.])
