Pro-face LT series, Hardware Manual

Page: 118 / 143

Communication Interface
118
Presentation
Introduction
The LT is equipped with an IEEE802.3 compliant Ethernet interface that transmits
and receives data at 10 Mbps or 100 Mbps.
Ethernet Interface
The figure shows the location of the RJ45 Ethernet interface on the rear module:
Do not confuse the RJ45 Ethernet interface with the RJ45 serial interface.
NOTE:
When you use a 1:1 connection to connect to a device such as PC, you can
use a cross cable, but we recommend using a hub.
Characteristics
The table describes the different Ethernet characteristics:
*/% % / *
Characteristic Description
Connector type RJ45
Driver
z
10 M half duplex (auto negotiation)
z
100 M full duplex (auto negotiation)
Cable type Shielded
Automatic cross-over
detection Yes