Pro-face GP-4402WW, Hardware Manual

Page: 51 / 62

GP-4402WW/GP-4502WW Hardware Manual
51
How to Connect the Power Cord
This figure shows a connection of the power cord:
This table explains how to connect the power plug:
NOTE:

Do not solder the wire directly to the power receptacle pin.

The power supply cord should meet the specification mentioned above. Be sure to twist the
power cords together, up to the power plug, for EMC cancellation.
Step Action
1 Remove the power cord from the power supply.
2 Remove the power plug from the panel.
3 Remove 7 mm (0.28 in) of the vinyl cover off the ends of the power cord wires.
4 If using stranded wire, twist the ends. Tinning the ends with solder reduces risk of fraying and
ensures good electrical transfer.
5 Connect the wires to the power plug by using a flat-bladed screwdriver (size 0.6 X 3.5).
6 Tighten the mounting screws using the defined torque: 0.5...0.6 N·m (5...7 lb-in).
7 Replace the power plug with the power connector.