Pro-Cut X9D, Technical Manual, Page: 27 / 64

WWW.PROCUTUSA.COM PG /
27
If the ALERT light is illuminated, the machine is unable to fully adjust for run-out. This difficulty could be
due to looseness of fittings, irregular run-out, damage to wheel bearings or other components, or other fac-
tors relating to set-up. The best procedure is to loosen the machine from the adapter, check adapter and
vehicle setup, rotate the adapter locator pin 180 degrees, and attach the machine again. Make sure that the
machine is adequately supported by the trolley. Run the adjustment procedure and the machine will should
adjust for run-out. If ALERT appears repeatedly, there is most often a problem with the vehicle. You should
dismount the machine and check for a damaged wheel bearing or CV joint. Such problems will have to be
addressed before match-machining is possible.
If the machine seems to be having excessive difficulty in adjusting for lateral run-out, consult the trouble-
shooting section on the Supertech app or at www.procutusa.com.
MACHINING ROTORS
STEP 3: ADJUST FOR LATERAL Run-out
(1 Minute)
CONTINUED
DRO computer in READY
mode displaying speed.
NOTE
DRO computer compen-
sated for lateral run-out to
0.0006” and ready to cut.
50
0
.
0006