KG-12-FS
3
NEVER USE HANDS OR FINGERS TO FEED PRODUCT INTO THE BOWL AREA, ALWAYS
USE THE STOMPER OR PUSHER (1)* INCLUDED IN PACKAGE.
DO NOT LEAVE THE MACHINE UNATTENDED WHILE IN OPERATION.
THIS EQUIPMENT MUST BE CONNECTED TO A THERMALLY PROTECTED OUTLET.
NOTE:
FOR ID NUMBERS REFER TO THE CORRESPONDING DRAWING AT THE END OF
THIS MANUAL
II.- UNPACKING:
1.- WHILE UNPACKING MACHINE TAKE SPECIAL CARE IN REMOVING THE COMPONENTS
AND MAKE SURE THAT ALL ARE ACCOUNTED FOR.
LOOK FOR THE FOLLOWING ITEMS:
1
COMPLETE GRINDING UNIT; INCLUDING HEADSTOCK (13), FEED SCREW (16),
HEADSTOCK RING (20), KNIFE (18) AND PLATE (19) .
1
STOMPER OR PUSHER (1).
1
PRODUCT TRAY (2).
4
RUBBER LEGS (4) (FOR MODEL KG-12-FS).
1
SUPPORT TRAY (10) (FOR MODEL KG-12-FS).
1
WRENCH (29) FOR SUPPORT TRAY NUTS (FOR MODEL KG-12-FS)
1
BOTTLE (25) OF FDA APPROVED GREASE.
III.- INSTALLATION:
1.
-
BEFORE CONNECTING THE MACHINE TO THE POWER SUPPLY, PLEASE FOLLOW
THESE EASY ASSEMBLY AND PREPARATION STEPS:
A.-REMOVE
HEADSTOCK
RING(20)
FROM
HEADSTOCK(13)
BY
ROTATING
COUNTERCLOCKWISE, PULL OUT KNIFE(18) , PLATE(19) AND FEED SCREW(16).
ALSO UNSCREW THE KNOB(8) TO ALLOW REMOVAL OF GRINDING HEADSOCK(13).
B.-WASH WITH AN APPROVED DETERGENT, RINSE AND DRY THE FOLLOWING
COMPONENTS:
HEADSTOCK(13),
FEED
SCREW(16),
HEADSTOCK
RING(20),
KNIFE(18), PLATE(19) , STOMPER(1), AND TRAY(2).
C.-REASSEMBLE THE COMPONENTS THAT WERE REMOVED FOR WASHING BY
FOLLOWING THE REVERSE ORDER IN LETTER “B", BE SURE THAT THE SHARP END
OF THE KNIFE(18) FACES FORWARD, AND THAT THE NOTCH OF THE PLATE(19)
ALIGNS WITH THE PIN(9) ON THE BOTTOM OF THE HEADSTOCK (SEE DETAIL "B").
PIN ON THE BOTTOM OF THE HEAD.
WHEN TIGHTENING THE HEADSTOCK RING(20), TENSION SHOULD BE FIRM BUT NOT
TOO TIGHT, USE ONLY HAND FORCE.
E.- INSTALL THE PRODUCT TRAY(2):
MODEL KG-12-FS: WITHDRAW THE NUTS(22) AND WASHERS(21), PUT THE
SUPPORT
TRAY(10) AND REPLACE WASHERS(21) AND SCREW NUTS(22) WITH WRENCH(29)
INCLUDED WITH THE UNIT, NOW INSERT THE NECK OF THE TRAY(2) INTO THE
HEAD STOCK (13) AND PLACE THE BACK PART OF THE TRAY(2) ONTO THE SUPPORT
TRAY(10).
F.- PLACE TH
E STOMPER(1) INTO THE TRAY’S NECK.