GB11
IMPORTANT:
the installer is responsible for any damage or injury resulting from
incorrect installation.
To guarantee correct operation, the appliance must be installed on a perfectly flat
surface.
For cut-out dimensions, see the figure below.
Dimensions in mm
For
flush mounted installation or setting into a marble worktop
, contact
the After-sales Service for the installation kit and necessary instructions.
•
4812 310 19277 Installation kit for marble worktop;
•
4801 211 00112 Installation kit for flush fitted worktop.
To guarantee correct operation, the appliance must be installed on a perfectly flat
surface.
The worktop must be 30-60 mm thick.
If necessary, cut the kitchen unit and worktop to fit before installing the hob.
Clean the cutout of any remaining dust that could compromise appliance
operation.
If a column unit is installed adjacent to the hob, leave a distance of at least 100
mm from the edge of the hob.
1.
Position the clips (
A
) in the spaces provided on the hob trim (Fig. 3) if not
already positioned.
2.
Measure the centre point of the vertical sides of the cut-out (Fig. 1)
3.
Fit the brackets (
C
) in the centre of the vertical sides, aligning the upper
edge of the brackets so that they are flush with the worktop surface (Fig. 2).
4.
Fix the brackets with the 4 screws supplied (
B
) using the holes provided.
5.
Insert the hob in the cutout, making sure the clips (
A
) are secured in the
spaces provided (Fig. 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Undercounter oven installation
•
If an oven (which must be of our manufacture) is to be installed under the
hob, ensure it is equipped with a cooling system and observe the distances
given in the figure to the side.
•
There must be nothing between the cooktop and the oven (cross rails,
panels, brackets, etc.).
INSTALLATION AND FIXING
ASSEMBLY
490
+2
0
580
510
483
553
min. 50
52
+1
0
560
+2
0
R min. 6,5
max. 8
C
B
A
5 mm
