INSTALLATION DIRECTIONS
LED Recessed Light Kit
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
*MAX 6 LIGHTS IN SERIES
WE RECOMMEND Y DISTRIBUTOR BEFORE FIRST
LIGHT IF MORE THAN 6 LIGHTS ARE REQUIRED FOR
ONE AREA.
*BEFORE CONNECTING INPUT (MALE) AND OUTPUT (FEMALE), LINE UP THE ARROWS FOR PROPER ALIGNMENT THEN INSERT.
*WHEN INSTALLING LOVO RECESSED LIGHTING IN AN INSULATED CEILING
WE RECOMMEND A VAPOR BARRIER BOOT OR RECESSED LIGHT INSULATION
BOX ENCLOSURE. NON-INSULATED CEILINGS DO NOT REQUIRE ANY VAPOR
BARRIER PROTECTION.
*BEFORE CONNECTING INPUT (MALE) AND OUTPUT (FEMALE), LINE UP THE
ARROWS FOR PROPER ALIGNMENT THEN INSERT.
THICKNESS
MAX: 20mm
Cut the installation hole of 4.15” (105.3mm) into the ceiling
(Figure 1). For open joist (new construction) scenario, mount
optional New Construction Rough-In-Plate.
Run your Lovo™ FC cabling from power supply to optional
PWM dimming control then to the lights. (Figure 2)
When you are ready to connect the light, Line up the arrows
embossed into each FC connector and connect the input
plug to the socket outlet. Push together until the green end
of the input plug is no longer visible within the output plug.
(Figure 3)
1.
2.
3.
Place the LED recessed light into the ceiling by pushing up
on the spring flanges on the side of the light (beware of
the force of the tension spring). Push the flanges into the
hole provided and slowly work the light up until the trim
ring covers the opening. (see Figure 4, 5 and Clearance
Information section).
4.
CEILING
INSULATION
JOIST
CLIPS
PLG-RCSL4-10W-24V
FC CONNECTOR
POWER SUPPLY
OPTIONAL:
POWER SUPPLY
FC CONNECTORS
OPTIONAL:
DIAMETER: 105.3mm
DESIGNED AND IMPORTED BY PRISM LIGHTING GROUP™ | NORTH AMERICA | 1-866-620-1380 | WWW.PRISMLIGHTINGGROUP.COM
Lovo™ Slim
LOW VOLTAGE
PWM WALL DIMMER
-
-
-
LOW VOLTAGE
SMART WALL
CONTROL PANEL
SMART CONTROL
RECEIVER
OR WIRELESS REMOTE
LOW VOLTAGE
PWM WALL DIMMER
-
-
-
LOW VOLTAGE
SMART WALL
CONTROL PANEL
SMART CONTROL
RECEIVER
OR WIRELESS REMOTE