12
Regular Use
To get cold water just push cold water tap with a cup. You can turn water cooler off with a blue/
green switch on the back of the dispenser. It is recommended to keep coller always on to prevent
secondary water pollution.
To get hot water push safety button first, then push hot water tap with a cup. You can turn water
heater off with a red switch on the back of the dispenser.
Caution! Hot water up to 200 °F (95 °C)!
Please note that R.O. membrane needs up to 50 hours of active operation before reaching peak
performance in terms of water flow, recovery and rejection rates.
For your safety and peace of mind please unplug the dispenser from the electrical outlet and shut
off the inlet valve before servicing your R.O. system such as changing filters or membrane, or dur-
ing vacations.
Tips:
■
If your dispenser is provided with optional filtered water outlet you may connect refrigerator, ice
maker or extra faucet.
■
Operating the system using softened feed water greatly reduces the chances of membrane fail-
ure and prolongs filters and membrane service l fe.
Changing Filters and Membrane
This R.O. system contains the replaceable components critical to the efficiency of the system. Re-
placement of a component should be with one of identical specifications, as defined by the manu-
facturer, to assure the same efficiency and contaminant reduction performance.
To reduce the risk of water leakage or flooding, and to ensure optimal R.O. system performance:
■
Change the disposable pre-filters every 6 months or sooner if you observe a noticeable reduc-
tion in water flow rate.
■
Change the disposable post-filter every 12 months or sooner if you observe a noticeable reduc-
tion in water flow rate.
■
Change the disposable R.O. membrane every 36 months or sooner if you observe a noticeable
reduction in water flow rate.
Failure to replace the disposable filters & membrane at recommended intervals may lead to re-
duced system performance and cracks in the filter housings, causing water leakage or flooding.
Please note the capacity of the filters and membrane is limited. Their service life depends on the
degree of contamination of the water supply and system usage. All terms apply to normal house-
hold use. Actual performance may vary. You may need to change filters or the membrane sooner
than indicated f you notice chlorine or other tastes or smells, etc. Manufacturer recommends a
TDS test every six months.
Replacement Filters:
■
K871 (sediment pre-filter)
■
K870 (activated carbon pre-filter)
■
K858 or K856 (high-production R.O.
membrane)
■
K880 (activated carbon post-filter and
conditioner)
Optional post-filters which can also be used
instead of K880:
■
K875 (granular activated carbon post-filter)
■
K873 (granular activated carbon with
schungite natural mineral post-filter)
■
K870 carbon block pre-filter may also be
used as a post-filter.
To prevent leakage or cracks and ensure the safety of operation and top performance do not
disassemble the filters or try to regenerate them.
