PN 6355 Rev A
Page 1
© 2006 Printek, Inc. All rights reserved.
PrintekMobile Group, Printek Inc.
Telephone: 888-211-3400
1517 Townline Road, Benton Harbor, MI 49022
FieldPro Model RT43 Quick Setup Guide
**
*
Maximum battery capacity is reached only after completing three
complete charge and discharge cycles. PrintekMobile recommends
completing three cycles before deploying your printer for best
results.
FieldPro printers may be operated directly from an external power
source without a battery present. If no battery is to be used, battery
charging may be skipped. (A battery compartment cover is available
from PrintekMobile).
With media rolls of less than 4” width we recommend addition of a
second paper guide. See reverse for details.
***
Rear
1
Charge the Battery
More detailed instructions can be found in the Operator’s Manual, available at www.printekmobile.com
Power Input
Port
I/O Port
Cover
Carrying
Strap
Paper
Door
Paper
Exit
(Tear Direction)
Top
Front
Start with Power Off
1
4
Printer will Prompt You to Press
if You Want to Enter Setup Menu
(More on Setup Menu, See Reverse)
2
1
Hold Feed Button,
then Press Power Button
3
4
Install Battery
*
(Loosen Carrying
Strap if necessary)
LED Should Illuminate
Connect Power Source
Charge Until LED Goes Out **
(Approximately 2-3 hours)
(PN 91373 AC Adapter, or
PN 91410 In-Vehicle Adapter)
2
Depress Door
Release Lever
Drop in
Paper ***
3
Perform Printer Test
2
Load Paper
Use this guide to configure your new FieldPro printer prior to use.
Printers may also be ordered from PrintekMobile pre-configured, if desired.
Power
Button
Power
LED
Battery
LED
Fault
LED
Feed
Button
Detail Other Side
Paper Door
Release
Battery
Release
Close Door
Paper Guide
3
Continue to Hold Feed Button
until Printer Beeps Twice.
LED will Flash, Test Page will Print