Princeton Instruments PI-MAX4, Manual

Page: 141 / 326

Chapter 7 WinX and Gated Operation 141
n.
Click on
Focus
.
•
If
Readout Mode
has been configured to
Use Region of Interest
, data
acquisition will immediately begin.
•
If, however,
Readout Mode
has been configured to
Use Full Chip
, the
system will display a pop-up dialog asking if this setting should be changed
to
Use Region of Interest
before entering focus mode. Click
Yes
and the
camera will momentarily begin acquiring data.
o.
Once it has been verified that the camera is operating properly and is in focus, halt
data acquisition.
p.
Proceed configuring the system for the desired experiment.
13.
Perform the following procedure to configure
Pulsers
as required:
a.
From the
Setup
pull-down menu, select
Pulsers
.
The
Pulsers
dialog is displayed, similar to that shown in Figure 7-14 .
Figure 7-14: Typical WinX Pulsers Dialog
b.
Select the
SuperSYNCHRO
radio button, and then click on the
Setup Pulser…
button. The
SuperSYNCHRO
dialog is displayed, as shown in Figure 7-15 .
Figure 7-15: Typical SuperSYNCHRO Dialog: Trigger In Tab
Click on the External radio button and modify the configuration as necessary.
4411-0139_0009
4411-0139_0010