Princeton Instruments NIRvana-LN, User Manual, Page: 33 / 122

Chapter 4 System Setup 33
3.
Click
Next >
to continue with the installation, and follow on-screen prompts.
4.
Once the installation has been completed, connect the detector to the host computer and
turn on the detector’s power supply.
5.
Reboot the host computer.
Windows will automatically detect the newly-installed GigE card.
REFERENCES:
For additional information, refer to Chapter 6, WinSpec/32 and
WinView/32 First Light Procedure , on page 49.
4.6 Mounting to a Spectrograph
The detector must be properly mounted to the spectrograph to take advantage of all the
available grouping features. Depending on the spectrograph and detector type, special
adapters may be required to mount the detector to the spectrograph. The appropriate
adapters should have been included with your system if the spectrograph type was indicated
when the system was ordered.
Refer to the adapter mounting instructions in
Appendix C, IsoPlane 320 Mounting , on
page 105, or the quick-start instructions that may have been shipped with the system.
WARNING!
An LN-cooled detector must never be tilted more than 30° from
vertical, unless the “all-directional” Dewar option has been purchased.
If mounting the Dewar to a system requires the 30° limit to be
exceeded, you may have the wrong type of Dewar. Contact the factory
for assistance.
4.6.1 Focal Plane Distance
The distance to the focal plane from the front of the mechanical assembly depends on the
specific configuration as indicated in
Table 4-1 .
NOTE:
The housing for a detector has a 7.60” [19.3 cm] bolt circle.
Table 4-1: Focal Plane Distances
Cooling Reference Point(s) Distance
LN
Mounting Face (IsoPlane Nose) to Focal Plane 0.839” [31.3 mm]