Princeton Instruments NIRvana-LN, User Manual, Page: 32 / 122

32 NIRvana
™
-LN System Manual Issue 4
4.5.2 Install WinSpec/32
Perform the following procedure to install WinSpec/32 on the host computer:
NOTES:
1. Install the GigE Adapter card BEFORE installing the
WinSpec/32 application software.
2. Leave the interface cable disconnected from the detector until
you have installed WinSpec/32.
1. Insert the WinSpec/32 software installation CD into the CD drive on the host computer.
The installation program will automatically launch.
2. When the Select Installation Type dialog is displayed, select the desired type of
installation:
• Typical installs all required drivers and commonly installed program files;
• Complete
installs all available application drivers and features;
• Custom is used to select specific features and drivers for installation, as well as to
specify a custom installation directory. This is only recommended for use by
advanced users.
Figure 4-2 illustrates a typical WinSpec/32 Installation Setup dialog.
Figure 4-2: WinSpec: Select Installation Type Dialog
4411
-014
5_00
15