Princeton Instruments NIRvana-LN, User Manual, Page: 113 / 122

Appendix D WinX/LightField Cross Reference 113
D.2 LightField-to-WinX Terminology
Refer to Table D-2 for a list of LightField terms and their corresponding WinX terms.
Table D-2: LightField-to-WinX Term Cross Reference (Sheet 1 of 2)
LightField WinX
Active Area: Bottom Margin Post-Dummy Rows Parallel to Shift Register
Active Area: Left Margin Pre-Dummy Shift Register Columns
Active Area: Right Margin Post-Dummy Shift Register Columns
Active Area: Top Margin F.T. Dummies or Frame Transfer Dummies
Active Area: Top Margin Pre-Dummy Rows Parallel to Shift Register
Active Height Active Rows Parallel to Shift Register
Active Width Active Shift Register Columns
Always Closed (Shutter) Disabled Closed (Shutter)
Always Open (Shutter) Disabled Open (Shutter)
Analog Gain Controller Gain
Bit Depth ADC Resolution
Clean Cycle Height Number of Strips per Clean
Clean Serial Register Skip Serial Register Clean (deselected)
Clean Until Trigger Continuous Cleans
Closing Delay Shutter Close Compensation Time
Correct Pixel Bias Disable Pixel Bias Correction (PBC)
Custom Sensor Custom Chip
Custom Timing Custom Timing
Expose During Trigger Pulse Bulb Trigger
Final Section Count Number of Blocks
Final Section Height Minimum Block Size
N/A Vertical Shift
No Response Free Run
Normal (Shutter) Normal Shutter
Number of Clean Cycles Number of Cleans
Open Before Trigger (Shutter) PreOpen (Shutter)
Opening Delay Shutter Open Compensation Time
Output Signal Logic Out
Output Signal: Acquiring Logic Out: Acquiring
Output Signal: Always High Logic Out: Logic 1