12
EN
Switching on and off (fig. A)
The on/off button (1) can be operated by
hand or foot.
To switch on the appliance, press the on/
•
off button (1).
To switch off the appliance, press the on/
•
off button (1) again.
Temporarily storing the accessories
(fig. G)
The crevice nozzle (11), the brush nozzle (12)
and the upholstery nozzle (13) can be
mounted to the accessory holder (14) for
easily changing the accessories during use.
Mount the accessory holder (14) to the
•
tube (7).
Mount the crevice nozzle (11), the brush
•
nozzle (12) and the upholstery nozzle (13)
to the accessory holder (14).
Temporarily parking the suction
nozzle (fig. H)
To temporarily park the suction nozzle, use
•
the park position as shown.
Cleaning and maintenance
Before you proceed, we need you to pay
attention to the following notes:
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait until the appliance has cooled down.
- Do not immerse the appliance in water or
any other liquids.
Before you proceed, we would like you to
focus your attention on the following notes:
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
Regularly check the appliance for possible
•
damage.
Regularly clean the ventilation slots using a
•
soft brush.
Store the appliance in a dry place, out of
•
the reach of children.
To remove the accessory, pull the accessory
•
from the hose inlet (17) or the tube inlet (19).
Use
Unwinding and rewinding the
mains cable (fig. A)
The mains cable rewind button (2) can be
operated by hand or foot.
Before you proceed, we would like you to focus
your attention on the following notes:
- Do not unwind or rewind the mains cable
while the appliance is switched on.
- Always hold the mains plug to unwind the
mains cable. Do not pull the mains cable.
Before use, hold the mains plug and unwind
•
a sufficient length of the mains cable from
the back of the appliance.
After use, press the mains cable rewind
•
button (2) to rewind the mains cable back
into the appliance. Manually guide the
mains cable to make sure that it does not
swing back. Make sure that the mains plug
is correctly located.
Adjusting the length of the tube
(fig. E)
The extension tube (8) can be adjusted in
19 steps.
Keep the locking knob (21) pressed and
•
slide the extension tube (8) to the required
position.
Release the locking knob (21).
•
Adjusting the suction nozzle (fig. F)
The floor surface selector (10) can be set to
adjust the suction nozzle (9) to the required
floor surface. The floor surface selector (10)
can be operated by hand or foot.
For vacuuming on laminates, tiles, etc.,
•
press the corresponding part (A) of the
floor surface selector (10).
For vacuuming on carpets, press the
•
corresponding part (B) of the floor surface
selector (10).
