Princess auto pro point, User Manual

Page: 6 / 28

3-1/2" Band Saw
6
For technical questions call: 1-800-665-8685
8354789 V 1.01
OPERATION CONTROLS AND ADJUSTMENTS
MOVING THE CUTTING ARM TO THE VERTICAL POSITION
1. For shipping purpose, the cutting arm A (Fig. 2) has been locked in the horizontal position by the pin B
(Figs. 2&3). To move it to the vertical position, pull out the pin B, lift the arm. To re-lock it, align the hole in the
outer arm with the hole in the inner bracket and then re-insert the pin as far as possible. When moving the tool,
return the cutting arm to the horizontal position and lock by simply inserting pin B.
2. Fig. 4 shows cutting arm in the vertical position.
ON/OFF SWITCH & TRIGGER WITH SAFETY LOCK
WARNING! Make sure that the voltage is the same as that shown on the plate of the machine and that the
switch is “OFF” before connecting the tool to power.
1. Push the switch to the “ON” position A (Fig. 5).
2. Move the safety lock B (Fig. 6) away from the trigger C (Fig. 6), and than squeeze the trigger C to
start the motor.
Note: The band saw is designed with current-limiting to protect the motor. When the current exceeds 6 Amps, the
tool will stop automatically. To re-start it, the operator must release the trigger and re-squeeze it.
Note: You can start the motor by squeezing either trigger. It is not necessary to press both at the same time.
Releasing the trigger stops the motor.
Figure 3 Figure 4
Figure 5
Figure 2
Figure 6