Clean DCFT Release Sheets and Club & Conveyor Belts
(continued)
527-502revC_EN 01/2014
©McDonald’s Corporation · Planned Maintenance Manual
Page
4
of
4
6
Clean exterior of the toaster.
•
Clean exterior of toaster
unit and all parts with a
clean, sanitizer-soaked
towel sprayed with
approved degreaser
solution or McDonald’s
DR Concentrated
Disinfectant Cleaner.
•
Rinse exterior of unit using
a clean, sanitizer-soaked
towel.
NOTE: If streaking occurs,
spray a paper towel with KAY
Specialty Cleaner & Polish
and wipe down to polish the
exterior of the equipment.
Chemicals
Sanitizer solution, Degreaser
solution, and McDonald's
DR Concentrated
Disinfectant Cleaner, KAY
Specialty Cleaner & Polish
7
Turn the toaster ON.
Allow the toaster to warm up.
The toaster is now ready to
resume use.
8
Assemble optional club feed
extension.
•
Slide the slot on the left
side of the club feed
extension over the edge of
the club in-feed chute.
•
Position the center tab on
the club feed extension
behind the rear edge of the
club in-feed chute.
•
Position the outside tabs on
the club feed extension in
front of the rear edge of the
club in-feed chute.
•
Push the club feed
extension down until it is
positioned on the in-feed
chute.