Regarding
the electrical connection and everything else concerning the power supply, please
carefully, follow the instructions enclosed electrical diagram.
The connection must be made by using a 5-pole cable 5x1, 5mm (3 phases, 1 neutral, 1
grounding) and the power supply should be secured with 3-pole fuse (3CH16A).
Please note the warning stickers on the machine.
CAUTION
! The manufacturer bears no responsibility regarding any injury or accident that may be caused
due to faulty electrical wiring or faulty connections made by unspecialized personnel. Always use a
certified electrician.
1)
Mount and firmly screw tight the arms nr.1 and nr.2 on the Ironing Table
2)
Mount and screw tight the Electrical panel (nr.3) and arm nr.2.
3)
Install the Suspension arm (Vario) with light (nr.4) onto the arms nr.1 and nr.2.
4)
Remove the metal cover nr.5, to connect the steam pipes nr.7 and nr.8.
5)
Unscrew the metal clamp (nr.6). Screw together the joint of the steam pipe (nr.7) and the
rotating tube (nr.8). Then tighten the metal clamp (nr.6) again into its place.
6)
Place the metal cover (n.5) again into its place.
7)
Connect the steam pipe (nr.9) with the ball valve (nr.11) and tube (nr. 10) with the steam trap
and the water tank (nr.12) on the steam generator
8)
Connect the plug of the Iron (nr.13) with the socket on top of the K/6/2 condenser (nr.14) and
the steam hose with the steam valve on top of the K/6/2 condenser (nr.14).
9)
Plug in the power cable (nr.16) on to the K/6/2 condenser (nr.14) and the light cable (nr.17) to
the electrical panel (nr.3).
10)
Hang the steam iron from the suspension mechanism (nr.18) and adjust the height between the
Iron and the Ironing surface to be about 5cm.
11)
The machine is ready for use.
ASSEMBLY INSTRUCTIONS
ELECTRICAL CONNECTION
