Install Analog Clock
Installation Requirements
l
Refer to the Important Safety Instructions before installing, operating or performing maintenance of clocks.
l
Before installing a clock, verify the system Transmitter is operating properly and sending a signal with adequate building
coverage
Broadcast (Transmit) Schedule Transmitter with Internal Antenna: broadcasts its synchronized time continuously to the system
clocks and devices.
Broadcast (Transmit) Schedule Transmitter with External Antenna: broadcasts its synchronized time to the system clocks and
devices from the 39th to the 6th minute of the next hour and changes to a standby mode during the 7th to the 38th minute of
the hour (standard broadcast schedule). During initial power-up, the Transmitter broadcasts for 8 consecutive hours. After the
8 hour power-up period, the Transmitter reverts to its timed broadcast schedule. Power cycling the Transmitter also initiates an
8 hour continuous broadcast.
l
Clocks must be installed at a location within adequate transmission range of the Transmitter.
l
Manual Setting Analog Clock Models - verify its set up procedure is completed before the clock is installed.
l
Any damage to the clock due to improper wiring voids the warranty. It is at Primex discretion as to whether damage to the
clock was caused by improper wiring.
WARNING
Battery-powered models only: For sites with multiple Transmitters or repeaters, do not install clock batteries until the
clocks are located at their permanent installation location.
22
XR Analog Clock Install Guide
