PrimeVOLT PV 2KTL-S1/G2P, User Manual, Page: 28 / 53

An independent circuit breaker must be installed on the AC side of each
inverter to ensure that the inverter can be safely disconnected from the
power grid.
Do not connect loads between the AC output terminals of the inverter
and circuit breaker.
WARNING
WARNING
Step 1
Remove an appropriate length of the jacket and insulation layer from the AC output cable
using a wire stripper.
optional
optional in usual
NOTE
There are four types of AC terminals in use (choose one from four).
Please refer to the real object in the deliverables.
Step 2
25
5 . 2 . 2 Procedure of Connecting AC Cables
optional
Plug the AC connector into the inverter.
Step 3
It is recommended to use outdoor dedicated cables with multiple copper cores.
Lead the AC cable through the rubber nut, seal and so on. .
Step 4
Tighten three screws and ensure each screw cap does not exceed the surface, then install
AC connector as shown figure3 below.
Single-phase Grid-tied PV String Inverter User Manual
05 Electrical Connections