Primera DX850, Quick Start Manual

Page: 6 / 16

6. Now position the stock to correspond with the general area where the labels will be
dispensed.
7. Pull the loose end of the label stock forward under the Top Roller. Pull approximately
6 inches of label stock out beyond the Peel Edge. (Figure 2-5.)
8. Take the loose label stock and feed it between the Liner Idler Roller and the Liner Drive
Roller. (Figure 2-6.) In order to feed the label stock between the rollers, the Liner Idler
Roller should be in the unclamped position. (See Figure 2-10 for a detailed diagram of the
Liner Idler Roller positions.)
Note:
This procedure assumes that the first 6 inches of labels will not be dispensed using the Label
Dispenser. Of course, you may still peel these labels by hand.
6 DX850 Label Dispenser
Figure 2-6.
Figure 2-5.
Tip! See Section 5 for
a Label Path diagram.