Programming the user code
:
A. Press the red button(f)(see diagram 2), then release it and display on the panel will show "
SET-CodE
".
B. Now press your 3-8 numbers that you wish to use as a new user code, and press "START" to confirm
immediately. The display will show "IN" and numbers you inputted, which means the new user code is
confirmed.
Programming the master code:
A.
Press the red button, then release it and display on the panel will show "
SET-CodE
" and press "START"
immediately. The display on the panel will show "
oLd-CodE
"
B.
Input the old code , (The factory pre-set code is 8.8.8.8 ) and then press "START", the display will show
"SET", now input your new 3-8 numbers and press "START" to confirm., and the display will show "
rE-
INPUT", and then input the new code for the second time,
and press "START" to confirm immediately.
C.
The display will show "IN". It means that new master codes is confirmed.
The reaction of wrong members:
If you input a incorrect code, the display will show "Error" and it will not open. If the incorrect code is used 4 times
consecutively, the display will show "ERROR" with buzzer accompany every second for 3 minutes. To disarm the
alarm, open the door with the override key, and then press the red button behind the door, the alarm will be
disarmed.
Battery replacement:
Press the button "START". If the batteries are low, the display will show "Lo-BAT", AND YOU SHOULD
REPLACE THE BATTERIES. The safe requires 4pcs of "AA" (1.5V ) batteries. Replace the old batteries, the
display will scan the status of the electronic lock system automatically. If it is in order, the display will show
"GOOD".
Override key:
For your convenience, we have engineered a manual override system for your safe. If you forget or misplace your
combination, remove the override cover plate, you will find the keyhole, insert the key into the keyhole and turn ,
turn the knob in a clockwise direction. This will manually open your safe any time. This product is supplied with 2
override keys.
Do not keep the key in your safe. In the event of battery failure, you will not be able to open the
safe.
Installing the safe
To reduce the risk of theft, the safe must be affixed to the floor or wall. For your convenience, there are holes in the
bottom and on the back, mounting bolts are included for use in solid masonry wall.
Place the safe on a solid and secure surface and mark the wall or floor through the holes in the safe. Ensure no
electrical cabling, gas or water pipes are hidden where you intend to drill. Using a 10mm masonry drill bit, frill at
the marked locations to a depth of 38mm. Insert the screw and split tube. Locate the safe, add the washers and
tighten the nets.
