PrimeAire PA5010E, Use & Care Manual

Page: 11 / 11

11
112912 1
TROUBLESHOOTING
Is the dehumidifier turned on?
Turn on the dehumidifier.
Is the power cord plugged into a grounded
3 prong outlet?
Plug into a grounded: 3 prong outlet.
See Electrical Requirements.
Has a household fuse blown, or has a circuit
breaker tripped?
Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
See "Electrical Requirements.”
Is the bucket installed properly?
Reinstall the bucket so that it fits all the way
into the dehumidifier.
Does the bucket need to be emptied?
Empty the bucket.
Is the water level float in place?
Remove the bucket. Make sure the float is
snapped in place. Reinstall the bucket.
All models have an automatic deicer that will
shut off the compressor and allow the fan to
run. This reduces the ice buildup on the coils.
The compressor will cycle back on when
the deicer senses the correct operating
temperature.
All models have an automatic deicer that
will shut off the compressor and allow the
fan to run. When the deicer senses the
correct operating temperature, the
compressor will cycle back on.
Is the control set to Continuous Run?
If you have selected Continuous Run, the
dehumidifier will run continuously. If the
humidity level is low, little or no water may
be collected.
The filter is dirty or obstructed by debris.
Clean the filter.
Dehumidifier will put out warm air under
normal operating conditions.