LIMITED 1 YEAR WARRANTY
Prime warrants this product to be free from manufacturing
defects for a period of one year from the original date of
purchase (“warranty period”). This warranty is limited to the
repair or replacement of this product only and Prime is not
liable for any consequential or incidental damage to other
products that may be used with this unit. This warranty is
effective only if such unit is returned to Prime not later than
thirty (30) days after the expiration of the warranty period.
Warranty is void if damage is due to neglect, misuse,
alteration, modification, improper installation, or repair by
other than Prime. This warranty is in lieu of all other
warranties express or implied. Some states do not allow
limitations on how long an implied warranty lasts or permit
the exclusion or limitation of incidental or consequential
damages, so the above limitations may not apply to you.
It is our experience that a product that fails prematurely due
to a manufacturing defect in materials or workmanship, will
generally do so very early in the product’s life cycle, often
the first or second time the product is used. Products that
are returned for warranty inspection after months or years
of continuous reliable service are usually the result of
normal wear and tear, which is not considered a defect in
materials or workmanship and therefore is not covered by
the warranty.
This warranty gives you specific rights, and you may also
have other rights which vary from state to state. If unit
should prove defective within the warranty period, return
within the time period set forth above prepaid with the
original purchase receipt to:
Prime Wire & Cable, Inc.
ATTN:
Timer
Warranty
280
Machlin
Court
City of Industry, CA 91789
SAFETY INFORMATION & SPECIFICATIONS
THIS TIMER IS A “POLARIZED” DEVICE.
One blade on the male plug is wider than the other
and is only intended for use with a polarized outlet.
Use with a three-pronged grounded outlet is also
acceptable.
THIS TIMER IS FOR USE WITH A 125 VAC POWER
SOURCE.
125 VAC / 60 Hz
DO NOT ATTACH A DEVICE THAT EXCEEDS THE UNIT
8 A / 1000 W Resistive
(General Purpose)
4.6 A / 575 W Tungsten
(Incandescent)
1/2 HP
(Horsepower Motor)
WARNING
Risk of Electric Shock
Keep children away. Unplug timer before cleaning. Fully
insert plug. Do not use in wet locations.
Risk of Fire
Do not use to control appliances that contain heating
elements (cooking appliances, heaters, irons, etc.). Do
not exceed electrical ratings. For Indoor Use Only.
AVERTISSEMENT
Risque de choc électrique
Gardez les enfants à l’écart. Débranchez la minuterie
avant de procéder au nettoyage. Insérez complètement la
fiche. N’utilisez pas l’article dans des endroits humides.
Risque d’incendie
N’utilisez pas cet article pour commander des appareils
qui contiennent des éléments chauffants (appareils de
cuisson, radiateurs, fers, etc.). Ne dépassez pas les
capacités électriques. Pour usage à l’intérieur seulement.
FCC REGULATORY STATEMENT
WARNING:
Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user authority to operate the equipment. This
device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Notes: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician
for help.
IC REGULATORY STATEMENT
Under Industry Canada regulations, this radio transmitter may
only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.