Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
3
1
1
2
2
Rear
Front
Lef
t
Right
Right Rear
(B) 48.00” ErgoRack
52.50” L2H1 AluRack
46.50“ L2H2 AluRack
60.00” L3/L4H2 AluRack
7.50”
(A) 96.00” ErgoRack
106.50” L2H1 AluRack
93.00” L2H2 AluRack
120.00” L3/L4H2 AluRack
Lef
t
Right
Rear
Front
FBM ASSEMBLY SEQUENCE
FBM-1009 ASSEMBL
Y
INSTR
UCTIONS–UNIVERSAL
FBM ASSEMBL
Y
1.2
Loosen bolt to allow strip nut
to freely slide into the opening
of each OEM Channel
MOUNTING BRACKETS
1.1
Remove OEM Rear Channel End Caps, and slide three
Mounting Brackets into each end of the OEM Channels.
1.3
Replace the End Caps, then set to distances shown below:
Use Dimensions A for 2 Crossbar models (ErgoRack only).
Use Dimensions B for 3 Crossbar models. (ErgoRack & AluRack)
Do not torque the Crossbar Mounting Brackets until Step 2.4.
Finger-tighten them into designated dimension to hold them in
place, then proceed to your Feature (FEA) Assembly Manual.
NOTE: Base Mounting Channels
are not included with this
FBM Kit. Channels shown are
OEM, and supplied by vehicle
manufacturer, and are for
illustrative purposes only.
To purchase non-OEM Channels,
please contact your authorized
distributor, or a Prime Design
Sales & Service Representative.
NOTE: Base, Rotation, Crossbar, and Side Rail features are shown for
illustrative purposes only. These features are not included with this Base
Mounting Kit, and must be purchased separately.
NOTE:
If installing the ErgoRack 2 Crossbar
model, see Page 8 AFTER installing all
Mounting Brackets.
