Primare A33.2, User Manual

Page: 10 / 12

>
Connecting the A33.2 Amplifier
4
p o W e r c o n n e c t I o n
Warning : Before connecting power check that the required supply voltage,
indicated on the back panel, corresponds to your local ac supply. If a
different voltage is stated on the type plate do not connect the amplifier to the
mains power, and seek advice from your dealer.
connect the mains power using the enclosed mains cable.
Note : always disconnect the amplifier from the mains power before
connecting or disconnecting any of the cables.
o u t p u t s
Loudspeaker outputs
connect the left and right loudspeakers to the corresponding terminals. the
terminals can accept speaker cables terminated with spade terminals, or bare
wires. to connect bare wires unscrew the terminal, pass the bare wire through
the hole in the terminal bolt, and clamp the wire in place by screwing the
terminal back down.
I n p u t s
connect the a33.2 to the preamplifier or processor using either the left and
right rca inputs, or the left and right XLr inputs, and put the input selector
switches in the appropriate positions. If you are using the rca inputs use high
quality stereo rca leads. If you are using the XLr inputs use balanced XLr
cables.
r e m o t e L I n k
to power the a33.2 on and off remotely from a primare sp31 processor
or pre30 preamplifier connect the remote output from the processor/
preamplifier to one of the remote LInk sockets on the a33.2, using a twin
core cable terminated in 3.5mm jack plugs. the second remote LInk socket
can be used to daisy-chain the remote output to further a30 series amplifiers.
to use the remote link switch the remote sW switch to the LInk position.