A 3 0 . 7 u s e r g u i d e
3
1 u n p A c k t h e A 3 0 . 7
Your A30.7 is supplied with the following
component:
•
Mains cable.
If this is missing please contact your supplier.
We recommend you retain the packaging in case
you need to transport the unit at a later date.
c o n n e c t s p e A k e r s
The A30.7 is designed to be connected directly to
up to seven loudspeakers.
•
For best performance, when using the A30.7
in a surround system connect your speakers as
shown opposite.
The terminals can accept speaker cables
terminated with spade terminals, banana plugs, or
bare wires.
For the best sound quality connect the red wire
from each speaker to the red terminal
and the black wire from each speaker to the black
terminal marked –.
To connect bare wires unscrew the terminal, pass
the bare wire through the hole in the terminal
bolt, and clamp the wire in place by screwing the
terminal back down hand tight.
3 c o n n e c t i n p u t s
•
Connect the A30.7 to each channel of the
preamplifier or processor using either the
unbalanced RCA input, or the balanced XLR
input, as appropriate.
•
Put the input selector switch in the
appropriate position for each channel.
If you are using the RCA inputs use high quality
stereo RCA leads.
If you are using the XLR inputs use balanced XLR
cables.
4 c o n n e c t p o W e r
Connect the power connector on the back
panel to your power outlet using the mains cable
supplied with the A30.7.
If this cable is not suitable for your power outlets
please contact your supplier for an alternative
cable.
WARNING:
Before connecting
power check that the required supply
voltage, indicated on the back panel,
corresponds to your local AC supply.
If a different voltage is stated on the type plate do
not connect the amplifier to the mains power, and
seek advice from your dealer.
WARNING:
Always disconnect the
A30.7 from the mains power before
connecting or disconnecting any cables.
getting stArted
Set up your A30.7 in four simple steps:
