USE INSTRUCTIONS
This product requires at least two (2) people for safe and correct lifting.
NOTE
Model: PVHA-100
Standz-Up Ladder Stand Aid
Distributed by Acheson Harriman Swan, LLC, 2407 W. Euclid Ave., Littleton, CO 80120
Customer Service Department 1-866-972-6168
www.primaltreestands.com
©2021 (rev. 1/21)
1
2
5
3
E
J
B
C
F
Lay out your ladder stand so that the bottom rungs are parrallel to the
Standz Up Ladder Aid base. Adjust the Left and Right Ladder Support
Brackets to match the correct width of your ladder stand.
NOTE: To increase stability, ALWAYS extend the brackets as wide
as possible.
Remove each M8 Quickclip from each Ladder Support Bracket .
Then lift and place the bottom rung of your ladder stand into the Left and
Right Ladder Support Brackets . Secure the ladder rung by
re-attaching each M8 Quickclip into the Ladder Support Brackets .
1
E
J
J
F
E F
E F
E F
With one person standing on either side of
the ladderstand, walk the stand upward, using
rungs of the ladder until it is properly and
firmly leanig against the tree.
2
5
Once the ladderstand has made a firm
contact with the tree, check that it is
securely leaning in place with both hands
on the ladder rails.
3
BEFORE removing ladderstand
from the Ladder Aid, it is
recommended to first secure any
ground level ladder securing aids
(such as installation straps)
4
Once secured, remove the ladder stand base from the Ladder Aid Stabilizer
Base, then make sure your ladder stand is properly level and angled on the
ground. Continue installing your ladder stand according to the manufacturer’s
instructions.
NOTE: Follow these instructions in reverse to remove your
ladder stand from tree.
NEVER
climb or use your ladder stand while
it is still connected to the Ladder Aid Stabilizer.
ALWAYS
f
ollow the correct manufacturer's
ground-level safety securing instructions of for
your ladder stand.
W A R N I N G
4
manufacturer
ground level
installation
straps
