3.
To fit the metal chopping blade (D) slide it over the shaft in the processor bowl. Be sure to
remove the protective plastic sleeves from the blades first! As with the disks the blades on
this attachment is very sharp so please be extra careful when handling.
4.
To fit the citrus press first put the citrus press shaft (C3) over the shaft in the processor bowl
with the ribbed edge uppermost. The ribbed edge drives a small cog in the strainer, which in
turn makes the cone spin round. When fitting the strainer ensure that the cog fits snugly over
the ribbed edge of the citrus press shaft.
Note that the strainer bowl has a safety
interlock tag like the one on the processor bowl lid
. This must be properly locked into the
safety interlock slot (1) before the unit will operate. Finally fit the cone.
Tip:
Use the pulse
control for best results with the citrus press.
5.
The Juice Extractor set (F) needs to be assembled before putting into the processor bowl. Fit
the flexible filter band (F2) around the inner wall of the extractor (F3). Fit the collar (F1) to
hold it in place the place the assembly into the processor bowl.
6.
The whisk stick (E) simply fits over the shaft in the food processor bowl.
Cleaning
When cleaning this product please observe the following precautions:
•
Always ensure the unit is switched off & unplugged from the mains
•
Exercise extreme caution when handling the metal blades. These are very sharp.
All parts except the main unit can be washed with warm soapy water, rinsed and dried
thoroughly. The non-see-through plastic & metal parts are OK to wash in a dishwasher but the
transparent, plastic parts may dull after repeated washing in the dishwasher.
Summary of Contents for PFP200
Page 4: ...2 NOTES ON ASSEMBLY...
