15
CHARGING INSTRUCTIONS
To recharge the batteries, follow the steps below:
Place your power scooter close to a standard electrical wall outlet.
Remove your key to turn the power OFF
Slide the charger port door open.
Plug the XLR connector of the charger to the charger port.
Plug the other end of power cord into a standard wall outlet.
When charging is completed, battery capacity indicator is shown.
Disconnect the charger power cord from the wall outlet when the batteries are fully charged.
Recharge battery only when the key is in off position. When indicator is in low status, this confirms the battery
needs recharging.
Note:
Always charge your batteries in well ventilated areas.
The charger is intended for indoor use only. Protect from moisture.
For maximum performance, it is recommended that you replace both batteries at the same time if the
batteries are weak.
If the vehicle will not be used for a long period of time, arrange to have the batteries recharged at least
once every month to avoid deterioration of the batteries.
According to the battery type and condition of the batteries, they usually can be fully charged in 4-10 hours.
This will be indicated when the status light in the battery charger side panel turns green. Charging the battery
longer than necessary will not harm the battery. We recommend that you charge the batteries for 8 to 10
hours after daily use.
BATTERY INDICATOR
A battery indicator is to provide information about the travelling range remaining.
Indicator
Travelling Range Remaining
Full
15 km Traveling Range Remaining
Green Area
7~15 km Travelling Range Remaining
Yellow Area
4~7 km Travelling Range Remaining
Red Area
1~4 km Travelling Range Remaining
End
0 Kilometer
Summary of Contents for S34P
Page 18: ...18 CIRCUIT DIAGRAM...
Page 19: ...19 BOM LIST DRAWING...
Page 40: ...40 CIRCUIT DIAGRAM BOM LIST DRAWING...
Page 41: ...41...