25
Pathrider 130 XL www.pridemobility.com
WARNING! When your scooter is in freewheel mode, the braking system is disengaged.
Disengage the drive motors only on a level surface.
Ensure the key is removed from the key switch.
Stand to the side of the scooter to engage or disengage freewheel mode. Never sit on
a scooter to do this.
After you have finished pushing your scooter, always return it to the drive mode to
lock the brakes.
NOTE: If the scooter is placed in freewheel mode (manual freewheel lever forward) while the key is in
the “on” position, the scooter will not run until the manual freewheel lever is pushed rearward and the
key is turned to the “off” position, then back to the “on” position.
Main Circuit Breaker (Reset Button)
When the voltage in the batteries becomes low or your scooter is heavily strained because of excessive
loads, the main circuit breaker may trip to protect the motor and electronics from damage. When the
breaker trips, the entire electrical system shuts down.
See figure 8
.
The reset button pops out when the breaker trips.
Allow a minute or so for the electronics to “rest.”
Push in the reset button to reset the breaker.
If the breaker trips frequently, you may need to charge the batteries more often or have your authorised
Pride Provider perform a load test on the batteries.
If the main circuit breaker trips repeatedly, see your authorised Pride Provider for service.
SECURING THE SCOOTER
Always secure the scooter in a forward-facing position in the vehicle. Attach the four tie-down straps to
the designated securement points.
See figures 9 and 9A.
Tighten the straps to sufficiently remove all slack.
Never attach tie-downs to adjustable, moving, or removable parts of the scooter such as armrests, shrouds,
and wheels. These items should be removed. Position the anchor points for the rear tie-down straps directly
behind the rear securement points on the scooter. The front tie-down straps should anchor to floor points
that are spaced wider than the scooter to provide increased lateral stability.
WARNING! Ensure scooters are properly secured to the motor vehicle during transport.
Scooters that are not properly secured can become a hazard to the user and to other
vehicle passengers in the event of a crash, sudden stopping, or swerving, as the scooter
could tip or slide out of place.
I I I . Y O U R S C O O T E R
Figure 9. Front Section
Figure 9A. Rear Section
FRONT SECUREMENT POINTS
(1 OF 2 SHOWN)
REAR SECUREMENT POINT
Summary of Contents for PATHRIDER 130 XL
Page 46: ...46 www pridemobility com Pathrider 130 XL N O T E S ...
Page 47: ......
