18
www.pridemobility.com
Jazzy 600 ES
V . C O M F O R T A D J U S T M E N T S
4. Flip up the seat latch safety.
See figure 8.
5. Squeeze the seat latch and release the seat from the front trapeze bar.
6. Slide the seat forward and remove it from the power base.
7. Remove the hardware that attaches the trapeze bars to the seat interface weldments.
See figure 15.
8. Move the trapeze bars up or down to the desired height.
NOTE: Change the seat dump by raising or lowering only one trapeze bar (front or rear).
9. Reinstall the hardware.
10. Reinstall the seat.
11. Reconnect the controller to the power base.
To change the seat height (United Kingdom Occupied Transit):
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
3. Remove the rear shroud.
See figure 2.
4. Disconnect the controller connector(s) from the power base.
See figure 3.
5. Remove the seat.
6. Remove the hardware that secures the four seat interface mounting brackets to the power base.
7. Place the four mounting brackets at the desired height.
8. Reinstall the hardware that attaches the four mounting brackets to the power base and ensure the hardware is
properly and tightly secured.
9. Reinstall the seat.
10. Reconnect the controller connector(s) to the power base.
11. Reinstall the rear shroud.
Figure 16. Seat Height Adjustment–UK Occupied Transit
SEAT PLATE
SEAT INTERFACE
MOUNTING BRACKET
HARDWARE
Summary of Contents for Jazzy 600 ES
