Pride COLT EXECUTIVE, Owner'S Manual

Page: 34 / 44

34 www.pridemobility.com Colt Executive
FAULT
CODE
CONDITION SOLUTION ERROR
MESSAGE
1
Batteries need charging Charge batteries as soon as possible.
N/A
2
Low voltage, batteries need
charge immediately Charge batteries as soon as possible.
Lo BAT
3
Over Voltage Unplug charger and/or turn scooter off, then back on.
HI BAT
4
Over Current Turn scooter off for a few minutes, then turn scooter
back on.
HI CUR
5
Park brake fault Remove the key from the key switch, then push the
manual freewheel lever to the drive (rearward)
position and restart your scooter.
BRAKE
6
Throttle control lever not centred
at start up Return the throttle control lever to centre position,
turn scooter off, then back on.
T POT
7
Throttle control lever broken or
faulted Contact your authorised Pride Dealer.
T POT
8
Motor fault Contact your authorised Pride Dealer.
MOTOR
9
Other fault Contact your authorised Pride Dealer.
OTHER
V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
What if all the systems on my scooter seem to be dead?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected.
Be sure the power down timer feature has not been activated. See V. “Operation.”
DIAGNOSTIC FAULT CODES
The diagnostic fault codes for your scooter are designed to
help you perform basic troubleshooting quickly and easily.
A diagnostic fault code and error message will be displayed
(
see figure 22 ) in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the fault code
condition is resolved and the scooter has been turned off,
then turned back on.
FAULT CODE
ERROR
MESSAGE
Figure 22. Fault Code Display