26
www.pridemobility.com
Celebrity XL Deluxe
I V . B A T T E R I E S A N D C H A R G I N G
!
Always fully charge your scooter’s batteries prior to daily use.
!
Maintain but do not exceed the psi/bar/kPa air pressure rating indicated on pneumatic tyres.
!
Plan your route ahead to avoid as many hills, cracked, broken or soft surfaces as possible.
!
Limit your baggage weight to essential items.
!
Try to maintain an even speed while your scooter is in motion.
!
Avoid stop-and-go driving.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-
cycle batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
How do I change a battery in my scooter?
MANDATORY! Battery posts, terminals, and related accessories contain lead and lead
compounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry, and amp-
hour (Ah) capacity. Refer to the specifications table in this manual and in the
manual supplied with the battery charger for recommended type and capacities.
WARNING! Contact your authorized Pride Provider if you have any questions
regarding the batteries in your scooter.
WARNING! Do not replace the batteries while the scooter is occupied.
WARNING! Do not mix old and new batteries. Always replace both batteries at the
same time.
WARNING! The batteries on your scooter should only be serviced or replaced by
an authorized Pride Provider or a qualified technician.
1. Remove the seat and rear shroud. See VII. “Disassembly and Assembly.”
2. Disconnect the battery tie-down strap.
3. Disconnect the battery harnesses by pulling them straight up. See figure 13.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old batteries.
6. Place a new battery in each battery well. Face the battery terminals toward the seat post.
7. Connect the red battery cable to the positive (+) battery terminal. See figure 13A.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Ensure the battery terminals are covered with the tiller boots.
NOTE: See figure 13B for correct hardware placement for battery terminal connections.