Quantum 6000 Series
www.pridemobility.com
29
V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat (Optional)
If your power chair is equipped with a power elevating
seat, you can change the seat height either through the
controller or through a toggle switch mounted to one of
the armrests.
To change the seat height through toggle switch:
1. Press forward on the toggle switch to raise the seat.
See figure 23.
2. Pull back on the toggle switch to lower the seat.
WARNING! Do not allow the motor to
run more than a few seconds after the
mechanism reaches the top or bottom
limit.
NOTE: For more information on operating the power
elevating seat through the controller, contact your
Quantum Rehab Provider.
WARNING! The power elevating seat
option is intended for use on a level
surface only. Never raise the seat from
its lowest position on an inclined
surface. Failure to heed this warning
can result in the power chair tipping
over.
WARNING! Never raise the seat from
its lowest position when operating
your power chair on bumpy or uneven
surfaces. Failure to heed this warning
can result in the power chair tipping
over.
WARNING! Never raise the power
elevating seat while your power chair
is in the freewheel mode.
WARNING! Always fasten the
positioning belt when operating the
power elevating seat.
NOTE: The power elevating seat option is equipped
with a system that reduces the speed of the power
chair by one half when the seat is elevated more than
1–2 in. (2.5–5 cm). Always check to be sure this sys-
tem is operating properly before using your power
chair.
Figure 23. Power Elevating Seat Toggle Switch
