Pride Mobility LiNX Controller, Basic Operation Instructions

Page: 10 / 16

10
3-Pin Off-board Charger/Programming
Socket
Only use the off-board charger that was supplied
with your power chair to recharge the power chair
batteries through the 3-pin socket located on the
front of the LiNX controller. See figure 3. Contact
your authorized Pride Provider for more information
or for a replacement battery charger.
Figure 3. 3-pin Off-board Charger Socket
NOTE: The socket may also be used for reprogramming the LiNX controller. Contact your
authorized Pride Provider for more information.
Lock Mode
The LiNX controller is equipped with a feature that enables you to “lock out” unauthorized users.
To lock the LiNX controller:
1. While the power is on, press and hold the on/off key for 4 seconds. The display will turn off immediately.
After 4 seconds, all LEDs will flash briefly.
2. The LiNX controller is now locked.
Controller Connector
This connects the LiNX controller to the power module located on the power base.
To unlock the LiNX controller:
1. While the LiNX controller is locked, press the on/off key to turn on the controller. All LEDs will flash
briefly. The LEDs will then slowly ripple from right to left, then will flash briefly.
2. Press the horn key twice before the LED ripple has completed, approximately 10 seconds. The
controller is now unlocked.
NOTE: If you do not press the horn key twice before the countdown is complete, the system
will beep and the LiNX controller will turn itself off. The unlock sequence must be completed
successfully before the LiNX controller will operate again.
Sleep Mode (if enabled)
The power chair controller features a sleep mode. Sleep mode is a built-in circuit that will automatically
shut off the main power if the joystick is not moved in any direction for a period of time. This time factor
is programmed into the controller. To restore power and continue, push any key on the keypad.
Out of Neutral at Power Up (OONAPU)
Your power chair joystick is equipped with Out Of Neutral At Power Up (OONAPU). If you power up the
system and the joystick is not in the neutral position, all of the lights in the speed setting indicator will
flash rapidly for as long as the joystick is out of the neutral position. Allow the joystick to return to the
neutral position and the fault will clear.