CAVA - MANUAL
18 | CAVA – Manual |
Fume Hood Presence Sensor (FPS)
The Fume Hood Presence Sensor (FPS) detects user movement in the vicinity of
the fume hood and sends a signal to Cava™. Based on the signal, Cava™
responds
by adjusting to a configurable fume hood mode. The FPS boasts a low profile and
allows for an adjustable coverage pattern.
See the FPS product submittal on
Dimensions, and Wiring.
Mechanical Installation
STEP 1
Remove the cover of the presence sensor by placing the blade of a small screwdriver in the
notch in the right side of the cover and prying upwards as shown. Always remove the cover
in this manner.
STEP 2
Drill two screw pilot holes and one wire passage according to the provided template in
STEP 3
Insert mounting screws partially into holes and route the wire harness through the wire
passage hole. Connect the wire harness to power and a Universal Input on the back of
Cava™ (see
section).
STEP 4
Route the wire harness through the hole in the presence sensor. Install the presence sensor
onto the mounting screws and tighten.
STEP 5
Connect the wiring harness to the presence sensor. Apply power to the unit and wait for the
LED to become a solid color. Green indicates no detection and red indicates detection.
STEP 6
Attach the cover by engaging the left side first and then gently snapping the right side of the
cover into place.
Shut off power to Cava™ before wiring the sensor. Always ensure
wiring is located clear of any moving parts to avoid damage.
CAUTION
