PREVOST Le Mirage XL II Ultimate, Service Manual

Page: 7 / 53

XL2 SLIDE-OUT SERVICE MANUAL
1. SLIDE-OUT
1.1 INNER STOPPER
The front slide-out is equipped with six inner
stoppers laid out in the following way: two
stoppers on the top horizontal member of the
slide-out, and two stoppers on each vertical
upright, while the rear slide-out is equipped with
only three stoppers (figure 2 and figure 3).
These stoppers are used to block the extension
of the slide-out, and to provide a support to
position perpendicularly the slide-out with the
vehicle structure. It is thus of primary importance
that the stoppers remain on the slide-out for the
automatic operation. If not, nothing will stop the
slide-out during its extension.
FIGURE
2 :
FRONT SLIDE
-
OUT
1.1.1 Maintenance
Check that the inner stopper screws are tight
and that no damage or deformation has taken
place for both the side and the upper stoppers.
1.1.2 Adjustment
1. Adjust the side inner stoppers at 1/8" from
the vehicle structure stoppers, and tighten
the screws (figure 4).
2. Adjust the upper structure stopper at 1/4"
from the slide-out structure and tighten the
screws (figure 5).
3. Adjust the slide-out inner upper stoppers so
they rest on structure stopper when the
slide-out is extended (figure 6), and tighten
the screws.
FIGURE
3 :
REAR SLIDE
-
OUT
FIGURE
4 :
SIDE INNER STOPPER
1/4"
UPPER INNER
STOPPER
SCREW
UPPER STRUCTURE
STOPPER
SCREW
FIGURE
5 :
UPPER STOPPERS
1.2 EXTERIOR EXTRUSION
The exterior extrusion function is to provide a
leaning surface for the inflatable seal. When
inflating, the seal leans against the extrusion and
presses the roof structure upward until it rests on
the inner side of the extrusion. This is to hold
back the roof structure (figure 5 and figure 6).
R3 7 May 3, 2002