PRESTO OWNER’S MANUAL
Page 8
POWER STAK PPS2200-62 NFO-21
S E C T I O N 3
INSTALLATION
A. INSPECTION
:
Upon receipt of the stacker, inspect the equipment com-
pletely to determine if there is any shipping damage, and
that the lift is complete. Presto tests and inspects every
piece of equipment prior to shipment. If damage is appar-
ent, a freight claim must be filed with the freight company.
Do not use the stacker if there appears to be any damage.
With the stacker in a lowered position, check the following:
•
Check for signs of damage especially to the back
cabinet that houses the battery, electrical/hydraulic
power pack.
•
Check all electrical and hydraulic connections
for tightness.
•
Remove back panel.
1. Turn key switch to "OFF" position.
2. Push in E-stop and unscrew the red knob,
3. Lift off back panel. There is enough wire to
the key switch to allow the panel to be set aside.
•
Inspect for any bent or damaged parts.
B. REMOVING FROM PALLET
PowerStak is shipped out on a pallet or skid. Prior to
removing the unit from the pallet or skid, remove all tie
down straps and packaging. Visually inspect the unit as
closely as possible.
With an overhead hoist or forklift, carefully pick up the
unit taking into consideration the center of gravity of the
unit. If you choose to pick the unit with an overhead hoist,
use a nylon sling and hoist with a minimum of 2,000-lb.
capacity. The nylon sling will not do any damage to the
steel construction of stacker. Pick the unit up. On con-
ventional masts use the top crossmember of the lift. On
narrow masts the cover must be removed to access lifting
equipment. Be careful of the stacker swinging once fully
lifted off the pallet or skid. Have all personnel completely
cleared from the area.
Pick the unit up approximately six inches above the pallet
or skid. Once raised, remove the pallet or skid from below
the lift. Do not move the lift around in the air. Lower the
stacker on the ground.
C. PREPARATION FOR USE
PowerStak left our factory in new condition. It has been
inspected and weight tested to assure all performance stan-
dards have been met.
Visually inspect the stacker for damage. Check for attach-
ments and accessories that may have been ordered. If there
is any damage or missing parts, report it to your carrier and
your Presto dealer immediately.
Remove all metal/plastic bands, cardboard and other mate-
rial used for shipping purposes.
Check to see if chains are in place, and that the lift system
is in working order. Inspect for oil leaks.
Connect battery cable. Check cables and wires on battery
charger as well as battery.
Note: The travel speed is preset at the factory. For
travel speed adjustment, please contact customer service
at Presto Lifts 1-800-343-9322
Chain adjustment must not be made to allow the forks to have a
lowered height greater than 3 1/2 inches. This measurement is from
the floor, to the top of the front tip of the forks. If higher fork adjust
-
ment is needed or if there are questions contact Presto Customer
Service at 800-343-9322.
