ROADRUNNER 185
©2021 Prestigio
13
2 Operating instructions device
Before you use the device, read the information in the "How to use it safely" section.
2.1 Charging the battery
Before using the DVR for the first time, fully charge the battery. It takes at least 1.5 hours to fully
charge the battery from a car power source or at least 3 hours from a USB port on your personal
computer (laptop).
Use your car's cigarette lighter: Charging will start automatically when the ignition is turned
on.
Use the micro-USB cable (not included): Connect the device to the power adapter (not
included) or a USB port of a computer/laptop with an output voltage of 5 V and a current of
at least 500 mA.
While the DVR is charging, the LED indicator of the charging mode will glow red. When the
device is fully charged, the LED indicator will glow green.
WARNING!
The built-in rechargeable battery is designed to terminate the last video recording when
external power is disconnected.
If you do not use the device for an extended period of time, you should fully charge the
battery once every two weeks.
2.2 Device installation
Installing the device on the suction cup mount
1. Follow the directional arrows on the unit to attach the suction cup and secure the unit. Slide
the bottom of the bracket to the mating part on the DVR body. Then turn the bracket until the
locking mechanism engages (you will hear a click).
2. Select a location on the windshield where you want to install the device. Optimal is the middle
of the windshield, next to the rearview mirror.
3. Degrease the glass, remove the protective film from the suction cup holder.
4. Press the mount firmly against the glass and lower the latch.
5. Route the cable along the ceiling and the front pillar of the car so that it does not interfere
with the driver's view.
6. Make sure that the routed cable does not interfere with the deployment of airbags and other
systems.
7. Select the angle of the device to get the best possible image from the DVR camera.
Installing the device on the additional attachment - 3M scotch tape
1. Select a location on the windshield where you want to install the device. Optimal is the middle
of the windshield, next to the rearview mirror.
2. Degrease the glass, remove the protective film from the adhesive part of the holder.
3. Press the mount firmly against the glass.
4. Route the cable along the ceiling and the front pillar of the car so that it does not interfere
with the driver's view.
