GETTING TO KNOW YOUR LARDER FRIDGE
INSTALLATION
Location
When selecting a position for your you should make sure the floor is flat and firm, and the room is well
ventilated with an average room temperature of between 12°C and 32°C.
Avoid locating your Larder Fridge near a heat source, eg. cooker, boiler or radiator. Also avoid direct sunlight in
lean-to’s or sun lounges. If you are placing your Larder Fridge in an out-building such as a garage or annex ensure
that the Larder Fridge is placed above the damp course, otherwise condensation will occur on the Larder Fridge
cabinet. Never place the Larder Fridge in a wall recess or into fitted cabinets or furniture.
When your Larder Fridge is working, the grille at the back may become hot and the sides warm. It must therefore
be installed so that there is 2cm (
3
/
4
”) of free space at the sides. There is a built in air flow grille at the back of the
Larder Fridge lid to ensure the correct distance from the rear wall. The Larder Fridge door can either open to the
right or the left, depending on the location which suits you.
See page 5 if you want to reverse the door swing.
Do not drape the Larder Fridge with any covering.
Levelling the Larder Fridge
Once the Larder Fridge is put in it’s final location, make sure it is level. To do this use the
two levelling feet at the front of the Larder Fridge. If the Larder Fridge is not level, the
doors and magnetic seal alignments may be affected.
Cleaning before use
Wipe the inside of the Larder Fridge with a weak solution of bicarbonate soda. Then rinse with warm water using
a ‘wrung-out’ sponge or cloth. Wipe completely dry before replacing the shelves and baskets. You could clean the
Larder Fridge externally with wax polish.
If you require more information refer to CLEANING on page 6.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the Larder Fridge.
If not, see the section called ELECTRICAL CONNECTIONS on page 4.
Before switching on!
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE LARDER FRIDGE.
The coolant fluid needs time to settle.
Before using your Larder Fridge
Before placing any food in your Larder Fridge, turn the Larder Fridge on and wait for 24 hours, to make sure it is
working properly and to allow the Larder Fridge to fall to the correct temperature.
3
Before use
Please read these instructions carefully before using your new Prestige
Larder Fridge. The Larder Fridge is for indoor and domestic use only.
INTERNAL LIGHT AND
THERMOSTAT
GLASS SHELF
BOTTLE STORAGE
LEVELLING FEET
(behind kick strip)
SALAD BIN
ADJUSTABLE
SHELVES
EGG TRAYS
