128-9456
Page 10
Page 10
OPERATING ON AUTOMATIC START UP TIMER MODE
Your system has the ability to automatically start the vehicle every 2 or 4 hours over a 48 hour
period. This feature is especially useful in cold climates where the only means to keep the engine
and engine fluids warm is to periodically start the engine.
WARNING!
Be certain that the vehicle is outdoors before using this or any remote vehicle starting
device. A running engine produces dangerous carbon monoxide fumes which can be
harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is
garaged.
TO BEGIN THE AUTOMATIC START UP TIMER
1. Turn the ignition key on then off.
2. Within 10 seconds, activate the RF start command two times. (Push the programmed channel
button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.
The vehicle, on a 2 or 4 hour interval basis, will automatically start, run for the preprogrammed
time (5,to 60 minutes), and then shut off. This will continue for 48 hours.
NOTE:
The automatic start up timer can also be initiated from the keychain transmitter. To do this:
1. Start the vehicle using the keychain transmitter by pressing and releasing the second channel
transmitter button 2 times.
2. Shut off the vehicle using the keychain transmitter by pressing and releasing the second
channel transmitter button 2 times.
3.Within 10 seconds of step 2, activate the RF start command two times
(Push the second channel button of your keychain transmitter 4 times).
The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated.
CANCELING THE AUTOMATIC START UP TIMER
To cancel the automatic start up timer do one of the following;
1. Start the vehicle manually with the use of the ignition key and depress the brake pedal
2. Remote start the vehicle using your keychain RF transmitter.
Programming New or Replacement 5BCR14RE, or 145BP Transmitters:
1) Turn the Ignition Switch to the ON position
2) Press and release the valet/programming switch found on the windshield receiver 3 times.
3) Press the Lock Button of each transmitter you want programmed until the lights flash or you
hear a chirp from the horn or siren.
4) Turn the ignition switch off.
The above action programs the Lock, Unlock, Start/Trunk, buttons which are typical for most
systems.
For additional channel programming beyond the option 1, option 2, etc,,,you can use any unused
button or combination of buttons not in use. In other words, to access option channels 4, 5, 6, 7,
you would do the following:
