128-9305
13 of 16
Page 13
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it. This
is an upgrade that can give you control of certain functions of your vehicle from a
telephone or in some cases a computer interface. Please check with your instal-
lation center for most recent Telematic Upgrades. If you had a Telematic Upgrade
installed, the manual supplied with the upgrade unit will provide a operators manual
advising of the features of the system and means available to control these features
of your vehicle.
PROGRAMMED TRANSMITTER NOTIFICATION (PTN)
Every time after Disarm when the ignition key is turned on, the unit's LED will report the
number of transmitters programmed into the system. This safety feature will alert you if an
unauthorized transmitter has been programmed into your vehicle's security system without
your knowledge. Typical from the factory, there will be a 2 flash, pause, repeated 3 times
indicating that two transmitters are programmed into the system. If you note additional flash
-
es, there may have been an additional transmitter added without your knowledge or authori-
zation. If you notice a change in the transmitter LED report pattern, you can correct this by
looking up how to erase and reprogram your transmitters found in the transmitter program-
ming guide. This reprogram operation will erase all unauthorized or unwanted transmitters.
PROGRAMMING NEW OR REPLACEMENT TRANSMITTERS (BANK 1)
Transmitter Model Name 145SP Is Also Found On Back Of
Transmitter Case. Use Battery CR2032
1) Turn the ignition key to the ON position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Press the Lock Button of each transmitter you want programmed until you hear
a chirp from the horn or siren.
4) Turn the ignition switch to the OFF position.
The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons
which are typical for most systems.
For additional channel programming beyond the option 1 button, you can use any
unused button or combination of buttons not in use.
In other words, to access option channel 5, 6, 7, you would do the following:
From step 3 above:
a) Press and release the valet/programming button 4 additional times to get to channel
5, then Press any unused transmitter button or button combination to program.
b) From a, press and release the valet/programming button 1 time to get to channel
6, then press any unused transmitter button or button combination to program c)
From b, press and release the valet/programming button 1 time to get to channel
7, then press any unused transmitter button or button combination to program.
NOTE:
Not all systems have channels above 3, check with your installation center
for options your system may or may not have.
