128-8205
5 of 16
Page 5
REMOTE PANIC OPERATION
The ARM or DISARM button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the ARM or DISARM button on the keychain transmitter for 3 or
more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the ARM or DISARM button on the transmitter
again for 3 seconds. If the button is not pressed, the alarm will automatically stop
after 30 seconds.
NOTE: Pressing the Trunk button of the transmitter while in the panic mode will cause
the sire n to immediately stop sounding.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
To activate the optional accessory, press and hold the Trunk/Key button on the keychain
transmitter for two seconds.
Anti Hi-Jack Mode Operation:
1. a) With the ignition switch on, and the doors closed, press and hold both the Lock & Unlock
buttons of the transmitter for 2 second to initiate the antihijack mode. The parking lights will
turn on for 1.5 seconds to indicate the mode was initiated. (Typically used when the operator
is evicted from the vehicle to initiate the antihijack mode.
b) If while the ignition is on, and a door is opened and then all doors are closed, the unit will
enter the antihijack mode. The parking lights will turn on for 1.5 seconds to indicate the mode
was initiated. Automatic Anti-hijack mode.
2. a) 60 seconds after initiation, the siren will begin to sound and the parking lights will begin
to flash.
3. a) 90 seconds after initiation, the starter inhibit circuit, (when installed) will be activated,
the siren and lights will continue until the battery is exhausted, or until the unit is reset.
NOTE:
If you are the unfortunate victim of a vehicle Hi-Jack, for your personal safety, it is best
to leave the vehicle as quickly as possible. Never attempt to oppose the thief in any way. If
the thief prevents you from leaving the vehicle, disarm the Hi-Jack feature to prevent the
system from sounding while you are in the presence of your captor. Once you exit the
vehicle, opening and then closing the door will initiate the Hijack feature the system will go
through the cycles mentioned above. Once the engine is turned off, it cannot be restarted if
the optional Starter Inhibit Circuit is install. The unit will continue to make noise from the siren
or the horn and the lights will continue to flash until the system is reset, or until the battery is
exhausted.
Disarming The Hi-Jack Feature
:
Anytime after the Hi-Jack mode has been triggered, the circuit can be disarmed simply by:
1) Turn the ignition switch from off to on
2) Within 10 seconds of 1, press and release the push-button override switch. Depressing
this switch one time will cause the security system to reset the Hi-Jack mode.
The circuit will not trigger again unless the door is opened and then closed while the vehicle
is running.
Car Locator:
Anytime during the armed mode, if the Lock button is pressed within range of the vehicle, the
siren will chirp 6 times and the parking lights will flash 12 times allowing easy location of the
vehicle in a crowded parking light.
